Meters on an electronics bench
For a bench multimeter, list the functions your test procedure uses and the levels you need checked. A production check at low DC voltage and a maintenance check on a current range call for different quotation details. Identify any special leads or adapters that belong with the instrument.
A common meter with two sets of leads
Consider a meter that moves between an incoming-inspection bench and a functional test station. One department might measure resistance with a fixture while the other checks a DC rail with handheld leads. Record the two uses on the same line as the meter's serial number. If the fixture stays in the protected work area, ask for the quotation to identify which checks can be made on the meter alone.
Write the bench number on the accessory bag as well as on the outward note. Someone receiving two identical meters after a shift change can then reunite each with its own leads.
Entry to a controlled work area
If the meters are inside an electrostatic-protected area, tell us how your site authorises visitors and who can release the bench. Mark probes, loggers and readouts that must stay together. For a unit still being fitted out, use the contractor’s actual site gate and identify who will accept the returned equipment.
Instrument and repair enquiries
- Decade resistance box repair assessment
- Frequency counter and timer repair assessment
- Infrared thermometer repair assessment
- Digital and analog multimeter calibration
- Thermometer calibration
- RTD sensor calibration
- Torque screwdriver calibration
- Tachometer calibration
- Bench DC power supply calibration
- Oscilloscope calibration
- Frequency counter calibration
- LCR meter calibration
- Lux meter calibration
- Bench voltage reference calibration
- Digital meter fault diagnosis
- Stopwatch and timer calibration
- Multifunction calibrator calibration
- Decade resistance box calibration
- Volumetric glassware calibration
- Panel ammeter and voltmeter calibration
- Bench function and signal generator calibration
- AC power source calibration
- Luminance meter calibration
- RF power sensor calibration
- Spectrum analyzer calibration
- Electronic calibrator repair assessment
- Oscilloscope repair assessment
- Chart recorder calibration
- Barometer calibration
- Bench DC power supply repair assessment
- Audio analyzer calibration and measurement enquiries
Related specialist work and guides
- Dry-block calibrator characterisation
- Patient monitor testing
- Infusion pump performance testing
- Defibrillator bench testing
- Calibration after repair
- Plan a biomedical equipment test visit
- Clean-air cabinet and fume hood qualification enquiries
- Salt spray chamber calibration and qualification enquiries
- Optical and analytical measurement enquiries
- Chromatography and titration system qualification enquiries